Take of the variator pulley and there should be a bolt just take it off. The kickstand is held onto the side of the scooter with a small pin located near the top of it.
Tri008 50cc Trike With Automatic Transmission Disc Brakes 10 12 Tires Casque Moto Original Casque Moto Casque
Remove all the plugs by pressing the pin slowly.
. What could be wrong if golf cart batteries charge for couple of hours then shut off. How do you take the governor off a moped. How to remove or put back restrictor on 50ccm scooter easy and DiyINSTAGRAM.
How to Remove a Scooter Governor. Loosen the top of the pin pull it slightly out and pull the kickstand off of the side of your scooter. How do you take a governor off a moped.
Unscrew and remove the bolt holding the front pulley wheel in place. Take off governor from a kymco scooter. Remove the belt from the crank and hold the inner pully half in tight to the engine while pulling the boss out.
Where is the governor Located on my scooter. Replace the front pulley wheel and tighten the bolt holding it in place. If they reach their full charge in 2.
Pulling it will allow you to remove the kickstart from the side of your scooter. Take the kickstand off of your scooter. How do you take the speed limiter off a scooter.
You may need to loosen the bolt head of the pin with a socket wrench prior to pulling it. Pull out the pin attaching the kickstart to the variator case of your Honda Metro. Pull the pin attaching the scooter to the variator box up and out and then pull the kick stand off of the box.
Pull the governing washer off of the front pulley rod. Unscrew the speed limiter and remove the screws from it and open it up. This will give you access to your scooters variator case.
How do you take the governor off of a kymco agility 50 scooter. Remove the kick stand. There may not be a governor as such it may be that the engine has been detuned or otherwise.
Remove the outer pully half. After opening the speed limiter you need to remove the metal piece that connects the wires to the scooter limiting the scooters speed. Remove the intake case from its position above the variator case.
Use an impact wrench to remove the nut on the front pully crankshaft right hand threads Hold the crank from turning with your hand. This washer acts as a governor for your scooter restricting the speed at which your variators belt can run.
How To De Restrict A Chinese Scooter Youtube
How To Tune A Carburetor In A Gy6 Chinese Scooter 150 Or 50 Cc Youtube
How To Put Back Or Remove 50ccm Scooter Speed Restrictor Youtube
0 Comments